Selector Lever Transmission Range Position Display Unit -Y26-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2013 Audi A4, 2012 Audi A4, 2011 Audi A4, 2010 Audi A4, and 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Unclipping Mounting Frame For Selector Lever Boot From Center Console

Courtesy of AUDI OF AMERICA, LLC

-- Move the selector lever into "N".

-- Unclip the frame -1- from the center console and remove it -arrows-.

-- Fold selector lever boot up.

-- Release the spring -2- and remove the Selector Lever Transmission Range Position Display Unit -Y26- -1- in direction of -arrow-.

Fig 2: Releasing Retaining Spring And Removing Selector Lever Transmission Range (TR) Position Display Y26 Upward

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector.