LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 556 (Controls & Housing - MULTITRONIC Transmission 0AW (Sedan) (As Of 11.2014)) >> 37 Controls, Housing >> Selector Mechanism >> Selector Lever Cable, Removing And Installing >> Removing

Selector Lever Cable, Removing And Installing: Removing

WARNING: This page is about a different car, the 2013 Audi A4, 2012 Audi A4, 2011 Audi A4, 2010 Audi A4, and 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Unclipping Mounting Frame For Selector Lever Boot From Center Console
GWWA37-10040Courtesy of AUDI OF AMERICA, LLC

-- Press the button on the electro-mechanical parking brake to activate it.

-- Move the selector lever into "D".

-- Pry the selector lever boot frame -1- out of the center console -arrows- using the Trim Removal Wedge 3409.

-- Insert the Socket And Key T40031 through the opening -arrow- in the selector mechanism and loosen the bolt on the selector lever cable approximately one turn.

Fig 2: Insert T40031 Through Opening In Selector Mechanism And Loosen Bolt On Selector Lever Cable One Turn
GWWA34-10994Courtesy of AUDI OF AMERICA, LLC
NOTE:

Only loosen the clamping screw - do not remove it.

The clamping screw is only accessible when the selector lever is in "D".

The selector lever must remain in "D" when the clamping screw is loose.

-- Vehicles with a 3.2L FSI engine: remove the left front muffler. Refer to FRONT MUFFLER, REMOVING AND INSTALLING for engine code CALA .

-- Remove the ball socket -1- on the selector lever cable from the selector shaft lever using the Pry Lever 80-200.

Fig 3: Disconnect Electrical Connector On Transmission By Rotating Twist Lock Counter-Clockwise
GWWA37-10837Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -2- from the cable mounting bracket.

-- Free up the selector lever cable.

NOTE:

Do not bend or kink the selector lever cable.

Ignore -arrow-.

-- Remove the four lock washers -1-.

Fig 4: Identifying Sound Insulation And Lock Washers
GWWA37-10755Courtesy of AUDI OF AMERICA, LLC
NOTE:

Replace the lock washers.

-- Remove the noise insulation -2- and slide it forward.

-- Remove the selector lever cable clip -1- sideways.

Fig 5: Identifying Selector Lever Cable Retaining Clip Sideways & Selector Lever Cable From Shift Mechanism
GWWA37-10402Courtesy of AUDI OF AMERICA, LLC

-- Remove the selector lever cable -2- from the selector mechanism.