Overview - Selector Lever Cable
WARNING: This page is about a different car, the 2013 Audi A4, 2012 Audi A4, 2011 Audi A4, 2010 Audi A4, and 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- Clip
- For the selector lever cable on the selector mechanism function unit
- O-Ring
- Replacing
- Bolt
- 13 Nm
- For selector lever cable adjustment
- Attached to the selector mechanism function unit
- Bolt
- 8 Nm
- Quantity: 2
- Selector Lever Cable Bracket
- Nut
- 13 Nm
- Quantity: 2
- Securely mounted on the selector lever cable
- The selector lever cable is secured to the support bracket
- Selector Lever Cable
- Do not bend
- Removing and installing. Refer to SELECTOR LEVER CABLE, REMOVING AND INSTALLING
- The selector lever cable must be replaced if the rubber grommet is damaged.
- Lubricate the ball socket lightly with Polycarbamide Grease G 052 142 A2 before installing.
- Make sure the rubber grommet on the transmission side is not twisted when installing.
- Checking and adjusting. Refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING
- Gearshift Lever