Wiring Harness In Transmission, Removing And Installing: Installing
WARNING: This page is about a different car, the 2010 Audi A4 and 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
-- Replace wiring harness connector o-rings and lightly coat with ATF.
-- Insert the wiring harness connector into the transmission housing while following the installation position.
-- Install the clip -A- on the wiring harness connector -B-.
-- Install the Mechatronic. Refer to MECHATRONIC, REMOVING AND INSTALLING .