Secondary Air Injection Right Combination Valve, Removing And Installing, Market-Specific 2: Installing

WARNING: This page is about a different car, the 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specification. Refer to OVERVIEW - SECONDARY AIR SYSTEM, MARKET-SPECIFIC 2 and Figure.

Install in reverse order of removal. Note the following:

NOTE:

Replace the seal.

The hose connections as well as the air guide pipes and hoses must be free of oil and grease before installing.

Secure all hose connections with hose clamps of the same type as those equipped by the factory.

In order to be able to securely mount the air guide hoses on their connectors, spray the screws on the previously used clamps with a rust remover.

-- Install the right catalytic converter. Refer to RIGHT CATALYTIC CONVERTER, REMOVING AND INSTALLING .

-- Install the plenum chamber bulkhead. Refer to OVERVIEW - BULKHEAD .