Exhaust Pipes/Mufflers, Separating

WARNING: This page is about a different car, the 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Chain Pipe CutterVAS6254

A separating point has been provided in the connecting pipe for individual replacement of the center or rear muffler
The separating point is marked by a depression around the circumference of the exhaust pipe.

Procedure

Fig 1: Separate Exhaust Pipes At A Right Angle At Separating Points

Courtesy of AUDI OF AMERICA, LLC

-- Separate the exhaust pipes at a right angle at the separating points -arrow- using a Chain Pipe CutterVAS6254.

-- When installing, position the clamping sleeves -arrows- on the center of the separating point

Fig 2: Identifying Double Clamps And Bolt Ends

Courtesy of AUDI OF AMERICA, LLC

-- Install double clamps so that the bolt ends do not project over lower edge of double clamp.

Fig 3: Identifying Installed Position Of Rear Double Clamps

Courtesy of AUDI OF AMERICA, LLC

Installed position: the threaded connectors face forward.

-- Install the exhaust system free of tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .