Right Exhaust Manifold, Removing And Installing: Installing

WARNING: This page is about a different car, the 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the seals and self-locking nuts.

-- Position the exhaust manifold with the catalytic converter seal and tighten the nuts. Refer to Figure.

Fig 1: Exhaust Manifold Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Install the right catalytic converter: for vehicles with manual transmissions/manual transmission 0AW, refer to RIGHT CATALYTIC CONVERTER, REMOVING AND INSTALLING . For vehicles with the automatic transmission 0B6 or automatic transmission 0B6, refer to RIGHT CATALYTIC CONVERTER, REMOVING AND INSTALLING .

-- Install the plenum chamber bulkhead. Refer to OVERVIEW - BULKHEAD .

-- Install the Heated Oxygen Sensor -G39-. Refer to HEATED OXYGEN SENSOR, REMOVING AND INSTALLING .

-- Install the noise insulations. Refer to OVERVIEW - NOISE INSULATION .

-- Install the front wheel. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .