Left Exhaust Manifold, Removing And Installing: Installing

WARNING: This page is about a different car, the 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the seal and self-locking nuts.

-- Position the exhaust manifold with the catalytic converter seal and tighten the nuts. Refer to Figure.

Fig 1: Exhaust Manifold Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Install the engine supports with the left engine mount LEFT ENGINE MOUNT, REMOVING AND INSTALLING .

-- Install the Heated Oxygen Sensor 2 -G108-. Refer to HEATED OXYGEN SENSOR, REMOVING AND INSTALLING .

-- Install the left catalytic converter: for vehicles with manual transmissions. Refer to LEFT CATALYTIC CONVERTER, REMOVING AND INSTALLING . For vehicles with the multitronic 0AW or automatic transmission 0B6. Refer to LEFT CATALYTIC CONVERTER, REMOVING AND INSTALLING .

-- Install the left front muffler. Refer to FRONT MUFFLER, REMOVING AND INSTALLING .

-- Install the noise insulations. Refer to OVERVIEW - NOISE INSULATION .

-- Install the plenum chamber bulkhead. Refer to OVERVIEW - BULKHEAD .