Selector Mechanism, Removing And Installing: Installing

WARNING: This page is about a different car, the 2010 Audi A4 and 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Tightening specifications. Refer to OVERVIEW - SELECTOR MECHANISM .

NOTE:

Lubricate the ball socket on the selector lever cable with Polycarbamide Grease G 052 142 A2 before installing.

Do not bend or kink the selector lever cable.

-- Adjust the selector lever cable. Refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .

-- Check the selector mechanism. Refer to SELECTOR MECHANISM, CHECKING .

-- Install the driveshaft. Refer to OVERVIEW - DRIVESHAFT for Rear Final Drive 0BC, 0BD, 0BE, 0BF, or 39 FINAL DRIVE, DIFFERENTIAL for Rear Final Drive 0BF and 0BE - Sport Differential .

-- Install the front muffler or the front exhaust pipe. Refer to OVERVIEW - MUFFLER for 2.0L, engine codes CAED, CAEB, CPMB, CPMA, or OVERVIEW - MUFFLER for 3.2L, engine code CALA .

-- Install the front ashtray. Refer to FRONT ASHTRAY, REMOVING AND INSTALLING .

-- Install the Multimedia System Control Head -E380-. Refer to Multimedia System Control Head -E380-, REMOVING AND INSTALLING .