LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 550 (Controls & Housing - Automatic Transmission 0B6 (Sedan)) >> 37 Controls, Housing >> Selector Mechanism >> Selector Mechanism, Disassembling And Assembling >> Shift Lock Solenoid -N110-, REMOVING AND INSTALLING >> Removing

Shift Lock Solenoid -N110-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2010 Audi A4 and 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Ashtray
GWWA68-10296Courtesy of AUDI OF AMERICA, LLC

-- Move the selector lever into "P".

-- Remove the Multimedia System Control Head -E380-. Refer to Multimedia System Control Head -E380-, REMOVING AND INSTALLING .

-- Remove the front ashtray. Refer to FRONT ASHTRAY, REMOVING AND INSTALLING .

-- Loosen the nuts -1, 3, 5 and 6- a few turns but do not remove them completely.

Fig 2: Disconnecting Selector Mechanism Electrical Connectors And Removing Bolts
GWWA37-10056Courtesy of AUDI OF AMERICA, LLC
NOTE:

This lowers the shift mechanism function unit slightly for better accessibility.

Fig 3: Cap, Bracket And Tabs
GWWA37-10871Courtesy of AUDI OF AMERICA, LLC
CAUTION:

The shift mechanism can be destroyed by broken clips, tabs or other objects.

  • Make sure no components or other objects fall into the shift mechanism. The shift mechanism must be replaced if that happens.

-- Open the retaining tabs -2 and 3- in direction of -arrow-, slightly raise the front of the sealing cap -A- and hold it in that position.

NOTE:

This prevents the retaining tabs from engaging again.

-- Using a screwdriver, open the upper retaining tab -1- on the cover in direction of -arrow- over the bracket -B- and remove the cover -A- upward.

-- Disconnect the connector on the Shift Lock Solenoid -N110-.

Fig 4: Pressing Retaining Hooks Into Shift Mechanism
GWWA37-10412Courtesy of AUDI OF AMERICA, LLC

-- Press the hooks -A- into the selector mechanism -arrow- and hold them in this position.

NOTE:

Replace the selector mechanism function unit if any of the hooks -A- are broken off.

-- Tilt the Shift Lock Solenoid -N110- in direction of -arrow- so that the ball head -1- comes out of the lever on the selector mechanism.

Fig 5: Identifying Shift Lock Solenoid N110
GWWA37-10413Courtesy of AUDI OF AMERICA, LLC

-- Remove the Shift Lock Solenoid -N110-.