Selector Lever Transmission Range Position Display Unit -Y26-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2010 Audi A4 and 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Unclipping Mounting Frame For Selector Lever Boot From Center Console

Courtesy of AUDI OF AMERICA, LLC

-- Move the selector lever into "N".

-- Unclip the frame -1- from the center console and remove it -arrows-.

-- Fold selector lever boot up.

-- Release the spring -2- and remove the Selector Lever Transmission Range Position Display Unit -Y26- -1- -arrow-.

Fig 2: Releasing Retaining Spring And Removing Selector Lever Transmission Range (TR) Position Display Y26 Upward

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector.