LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 548 (3.2L - Lubrication - Engine Code(S): CALA (Sedan)) >> 17 Lubrication >> Engine Oil Cooler >> Overview - Engine Oil Cooler

Overview - Engine Oil Cooler

WARNING: This page is about a different car, the 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

Danger of catalytic converter damage.

  • The oil level must not exceed the "MAX" marking.
NOTE:

If large quantities of metal particles or abraded material are detected during engine repairs, it may mean the crankshaft or rod bearings are damaged. To prevent damage, perform the following steps after completing the repair: carefully clean the oil channels and replace the oil spray jets, the oil cooler and the oil filter. 

Oil capacities, specifications and viscosity classes. Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE.

Oil injector jet for piston cooling. Refer to Fig 1.

Fig 1: Identifying Oil Spray Jet And Bolt
GWWA13-10106Courtesy of AUDI OF AMERICA, LLC
Fig 2: Identifying Oil Pan, Oil Pump And Oil Cooler Overview
GWWA17-10201Courtesy of AUDI OF AMERICA, LLC
  1. Nut
    • 9 Nm
  2. Oil Level Thermal Sensor -G266-
  3. Seal
    • Replace
  4. Oil Pan Lower Section
  5. Bolt
    • 9 Nm
  6. Lower Oil Baffle
  7. Bolt
    • Tightening specification and sequence. Refer to Figure.
  8. Oil Pan Upper Section
  9. Alignment Sleeve
    • Quantity: 2
  10. O-Ring
    • Insert into guide frame
    • Replace
  11. Bolt
    • 9 Nm
    • Install with locking compound. For the correct locking compound.
  12. Upper Oil Baffle
  13. Seal
    • Insert into guide frame
    • Replace
  14. Seal
    • Replace
  15. Bolt
    • 9 Nm
  16. Engine Oil Cooler
  17. Bolt
    • 9 Nm
  18. Oil Pump Drive Axle
  19. Pressure Spring
  20. Sleeve
    • Quantity: 2
  21. Mounting Bracket
  22. Bolt
    • 9 Nm
  23. Chain Sprocket for Oil Pump
    • Can only be placed onto drive axle in one position
  24. Bolt
    • 30 Nm + 90° turn
    • Replace
    • To loosen, counterhold on sprocket with Wrench - Pin Type3212.
  25. O-Ring
    • Replace
  26. Seal
    • Replace
  27. O-Ring
    • Replace
  28. Oil Pump
  29. Bolt
    • 20 Nm
  30. Bolt
    • Replace
    • Tightening specification and sequence. Refer to Figure.
  31. Seal
    • Replace
  32. Oil Drain Plug
    • 30 Nm
scientia non olet · About LEMON Manuals