Engine Oil Cooler, Removing And Installing: Installing

WARNING: This page is about a different car, the 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specification. Refer to OVERVIEW - OIL PAN/OIL PUMP .

Install in reverse order of removal. Note the following:

NOTE:

Replace the gaskets and seals.

Secure all hose connections with hose clamps of the same type as those equipped by the factory.

-- Install the After-Run Coolant Pump -V51-. Refer to After-Run Coolant Pump -V51-, REMOVING AND INSTALLING .

-- Install the lock carrier brace. Refer to OVERVIEW - LOCK CARRIER .

-- Check the oil level. Refer to ENGINE OIL, FILLING AND CHECKING LEVEL .

-- Fill the coolant. Refer to COOLANT, DRAINING AND FILLING .