A/C Pressure/Temperature Sensor -G395-, CHECKING

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

A/C Pressure/Temperature Sensor -G395-, checking the signal

NOTE:

The signal from the A/C Pressure/Temperature Sensor -G395- is checked as described in Guided Fault Finding for the A/C system using the Vehicle Diagnostic Tester in the "Guided Fault Finding" function.

The Vehicle Electrical System Control Module -J519- evaluates the A/C Pressure/Temperature Sensor -G395- signal. It is transmitted via the Data Bus to the Climatronic Control Module -J255- A/C display and control head. Refer to the appropriate SYSTEM WIRING DIAGRAM.

If a malfunction in the signal from the A/C Pressure/Temperature Sensor -G395- is detected, then the malfunction will be entered in the DTC memory of the Vehicle Electrical System Control Module -J519- and the Climatronic Control Module -J255- A/C display and control head. It will be necessary to the check the Vehicle Electrical System Control Module -J519- DTC memory when reading the DTC memory for the Climatronic Control Module -J255- A/C display and control head using the Vehicle Diagnostic Tester in the "Guided Fault Finding " function.

The A/C Pressure/Temperature Sensor -G395- measured values are displayed in the Vehicle Electrical System Control Module -J519- measured values block using the Vehicle Diagnostic Tester in the "Guided Fault Finding " function. The displayed temperature value is currently not used by the Climatronic Control Module -J255- A/C display and control head.