Recirculation Door Motor -V113-, REMOVING AND INSTALLING: Removing
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Move the passenger seats as far back as possible.
-- Turn off the ignition.
-- Remove the glove compartment. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .
-- Loosen the wiring harness -E- from the air intake housing.
-- Remove the bolts -B-.
-- Disconnect the actuator shaft -C- from the air recirculation door shaft -D-.
-- Mark the connector -A- if necessary (to rule out an interchange in the event several connectors are disconnected at the same time).
-- Disconnect the connector -A-.