Recirculation Door Motor -V113-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Installation is carried out in the reverse order while observing the following.

-- Connect the connector -A-.

-- Insert the actuator shaft -C- into the air recirculation door shaft -D-.

NOTE:

The actuator does not have a stop; therefore the actuator shaft -C- can be inserted into the air recirculation door shaft -D- at any position.

-- Install the bolts -B-.

-- Install the wiring harness -E- so that it cannot come in contact with any moving parts (for example, the actuating arm).

-- Install the removed parts in the opposite order.

-- Perform a basic setting and the output diagnostic test mode for the A/C system using the Vehicle Diagnostic Tester in the "Guided Fault Finding" function.

NOTE:

On this vehicle, the actuators are equipped with electronics. During the basic setting, a new actuator learns its position on the A/C unit and can then be activated by the Climatronic Control Module -J255- A/C display and control head (currently all actuators are identical) using the Vehicle Diagnostic Tester in the "Guided Fault Finding " function.

During the basic setting, the actuators are assigned and adapted corresponding to the switching sequence of the wiring. If this sequence does not conform the specification, the adjustment motors will adapt incorrectly and the door control will be wrong. Refer to MAIN WIRING DIAGRAM FOR A/C SYSTEM ACTUATORS (A/C system actuators block diagram).

-- Turn on the ignition.

-- Check the DTC memory for the Climatronic Control Module -- A/C display and control head and erase any displayed malfunctions, if necessary using the Vehicle Diagnostic Tester in the "Guided Fault Finding" function.