LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 544 (Refrigerant R134A Servicing (2 Of 2) (Sedan)) >> 87 Air Conditioning >> Pressures, Checking >> Checking Pressures On Vehicles With Expansion Valve And Receiver/Dryer (With Internally Regulated Compressor) >> General Information

General Information

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, and 2014 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Connect the A/C service station. Refer to A/C SERVICE STATION, CONNECTING .

Observe the test requirements. Refer to PRESSURES, CHECKING .

-- With the ignition switched off, check the pressure in the refrigerant circuit (using the service station). Refer to REFRIGERANT CIRCUIT, CHECKING PRESSURE WITH SERVICE STATION .

The pressures with the ignition turned off meet the specifications.

-- Start the engine.

-- Bring the engine speed up to 2000 RPM.

-- Observe the pressure gauge of the service station.

NOTE:

The switch pressures and design of refrigerant circuit switches are vehicle-specific.

Pressures must be measured at service connections; component locations of these connections are vehicle-specific. Refer to OVERVIEW - REFRIGERANT CIRCUIT (vehicle-specific repair information).