LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 543 (3.2L - Cooling System - Engine Code: CALA (Sedan)) >> 19 Cooling System >> Coolant Pump/Thermostat >> Electric Coolant Pump, Removing And Installing >> After-Run Coolant Pump -V51-, REMOVING AND INSTALLING >> Removing

After-Run Coolant Pump -V51-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Noise Insulation Panels
GWWA10-11071Courtesy of AUDI OF AMERICA, LLC
WARNING:

Risk of scalding due to hot steam and hot coolant.

  • The coolant system is under pressure when the engine is warm.
  • Reduce pressure by covering coolant reservoir cap with a cloth and carefully opening.

-- Open the coolant reservoir cap.

-- Remove the front noise insulation -1-. Refer to OVERVIEW - NOISE INSULATION .

-- Remove screw -1- and disconnect harness connector -2-.

Fig 2: Identifying After-Run Coolant Pump (If Equipped)
GWWA19-10599Courtesy of AUDI OF AMERICA, LLC

-- Place the Shop Crane - Drip Tray VAS6208 under engine.

-- Remove the After-Run Coolant Pump -V51- from the coolant hoses -arrows-.

scientia non olet · About LEMON Manuals