Windshield, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Windshield, Installing

NOTE:

Cross-section thickness of adhesive bead is determined by dimension of opening in nozzle tip and rate of application.

Dimensions for adhesive application:

Fig 1: Dimensions For Adhesive Application

Courtesy of AUDI OF AMERICA, LLC

Adhesive Bead
Glass/Paint Primer
Window

Dimension -a- = 8 mm
Dimension -b- = 12 mm
Dimension -c- = note the different spacing dimensions to the window edge. Refer to "Adhesive Bead" -item 2- in OVERVIEW - WINDSHIELD .

-- Position complete surface of nozzle -2- onto window.

Fig 2: Positioning Complete Surface Of Nozzle Onto Window

Courtesy of AUDI OF AMERICA, LLC

Application in direction of -arrow- for adhesive bead -1-.

-- Apply adhesive sealing material -1- all around on window -2- according to illustration.

Fig 3: Identifying Special Tool VAS 5237

Courtesy of AUDI OF AMERICA, LLC

-- With an undamaged removed window, apply adhesive to remaining bead.

-- Using suction cups, install the windshield.

CAUTION:

The window must be installed within 15 minutes or the adhesive sealing material will not adhere properly.

-- Center window along sides.

Distance from the window edge to the roof frame. Refer to "Windshield" -item 1- in OVERVIEW - WINDSHIELD .
Secure the window to the top of the roof with adhesive tape.

-- Before installing plenum chamber cover, first remove protective profile -2- from the frame.

-- Observe minimum curing time. Refer to MINIMUM CURING TIME FOR BONDED WINDOWS .