Overview - Rear Window, Sedan

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Window Overview

Courtesy of AUDI OF AMERICA, LLC

Rear Window
- Distance -a- to roof = 2 mm.
- Center the distance -d- to the >>D-pillar<<.
- Before removing, disconnect all electrical connectors and secure the terminals to the middle of the window on the inside using adhesive tape.
Adhesive Bead
- Bead width = 8 mm ^{± 2 mm}
- Bead height = 12 mm ^{+ 2 mm}
- Distances to the window edge:
  - Dimension -b- = 16.5 mm
  - Dimension -c- = 21.5 mm
  - Dimension -e- = 16.5 mm
Spacer
- Make 3 markings each on the top and bottom edges of the window.
Adhesive Stop Profile
- Distance to the edge of the window dimension f = 24 mm
- Bond the adhesive stop profile directly by the window defroster distributing wire.
- Window adhesive must not come into contact with the rear window defroster distributing wire.