Overview - Instrument Cluster
WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Observe notes on contact corrosion. Refer to CONTACT CORROSION .
NOTE:
All warning lamps in instrument cluster are fitted with light-emitting diodes. Instrument cluster must be replaced in the event of warning lamp failure.
- Oil Level Thermal Sensor -G266-
- Removing and installing. Refer to Oil Level Thermal Sensor -G266-, REMOVING AND INSTALLING .
- Oil Pressure Switch -F1-
- Removing and installing. Refer to OIL FILTER/OIL PRESSURE SWITCH .
- Connector
- For Data Bus On Board Diagnostic Interface -J533-
- Data Bus On Board Diagnostic Interface -J533-
- Overview. Refer to OVERVIEW - DATA BUS ON BOARD DIAGNOSTIC INTERFACE .
- Screw
- Tightening specification: 3 Nm
- Fiber Optic Cable Connector
- Seal with Fiber-Optic Repair Set - Connector Protective CapsVAS6223/9
- Instrument Cluster
- With Instrument Cluster Control Module -J285-
- Removing and installing. Refer to Instrument Cluster -KX2-, REMOVING AND INSTALLING .
- Multi-pin connector pin assignment. Refer to INSTRUMENT CLUSTER MULTI-PIN CONNECTOR CONTACT ASSIGNMENT .
- Connector
- For instrument cluster
- Screw
- 2.5 Nm
- Gap Cover
- Removing and Installing. Refer to INSTRUMENT CLUSTER GAP COVER, REMOVING AND INSTALLING .
- Screw
- 2.5 Nm
- Screw
- 2.5 Nm
- Fuel Level Sensor -G-
- Connector assignment. Refer to Fuel Level Sensor -G- CONNECTOR ASSIGNMENT .
- Removing and installing. Refer to FUEL DELIVERY UNIT/FUEL LEVEL SENSOR, REMOVING AND INSTALLING .
- Fuel Level Sensor 2 -G169-
- Connector assignment. Refer to Fuel Level Sensor 2 -G169- CONNECTOR ASSIGNMENT .
- Removing and installing. Refer to FUEL DELIVERY UNIT/FUEL LEVEL SENSOR, REMOVING AND INSTALLING
- Radio Frequency Controlled Clock Receiver -J489-
- Removing and installing. Refer to RADIO FREQUENCY CONTROLLED CLOCK RECEIVER, REMOVING AND INSTALLING .
- Screw
- 2.5 Nm
- Screw
- 2.5 Nm
- Connector
- For Radio Frequency Controlled Clock Receiver -J489-
- Windshield Washer Fluid Level Sensor -G33-
- Removing and installing. Refer to WINDSHIELD WASHER FLUID LEVEL SENSOR, REMOVING AND INSTALLING .
- Brake Pad Wear Sensor
- Left Front Brake Pad Wear Sensor -G34-
- Brake Fluid Level Warning Switch -F34-
- Engine Coolant Level Warning Switch -F66-
- Connector
- For Outside Air Temperature Sensor -G17-
- Outside Air Temperature Sensor -G17-
- Removing and installing:
- Vehicles through MY 2012. Refer to Outside Air Temperature Sensor -G17-, REMOVING AND INSTALLING, THROUGH MY 2012 .
- Vehicles from MY 2013. Refer to Outside Air Temperature Sensor -G17-, REMOVING AND INSTALLING, FROM MY 2013 .
- Removing and installing: