Rear Final Drive 0BE - Replacing, Flange/Driveshaft Shaft Seal: Installing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, and 2014 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Oil Seal Guide Sleeve T40247/1

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Pay attention to the following:

-- Fill the space between the sealing/dust lip halfway with Sealing Grease G 052 128 A1.

-- Coat outer edge of the seal with gear oil.

-- Place the new shaft seal -A- on the Seal Installer - Propshaft - Guide Sleeve T40247/1.

NOTE:

Make sure the shaft seal spring is in its installation position behind the sealing lip.

-- Push the Seal Installer - Propshaft - Guide Sleeve T40247/1 and the shaft seal -A- onto the pinion -B-.

-- Install the shaft seal all the way. Be careful not to bend it.

Fig 2: Identifying Oil Seal Installer T40247

Courtesy of AUDI OF AMERICA, LLC

-- Warm the flange/driveshaft -B- with a Inductive Heater VAS6414 or a Heating Plate to 115 °C (239 °F).

Fig 3: Locating Marked Position Of Flange/Driveshaft To Pinion

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Wear safety gloves.
If using a Heating Plate the temperature must be observed using a Digital Thermometer VAS6519.

-- Position the flange/driveshaft -B- on the pinion -A- so that the marking -arrow- lines up.

-- Install the flange/driveshaft with the Seal Installer - Hollow Shaft T10380.

Fig 4: Installing Flange/Driveshaft With The Seal Installer - Hollow Shaft T10380

Courtesy of AUDI OF AMERICA, LLC

Install the circlip -1- as follows:

Fig 5: Installing Locking Ring (Circlip)

Courtesy of AUDI OF AMERICA, LLC

Always replace the circlip -1-.
The bevel on the inner diameter of the circlip -arrow A- faces out, toward the driveshaft.
The wide tab on the circlip -arrow B- must be on the right side, as illustrated.

-- Measure the thickness of the old circlip -1-.

-- Install a new circlip -1- having the same thickness as the old one.

-- Install the new circlip -1-.

NOTE:

A new circlip -arrow- must be selected when replacing the flange/driveshaft.

For this, determine and insert the thickest circlip -arrow- that can still be installed in the groove.

-- Fill with gear oil in the rear final drive 0BE. Refer to GEAR OIL IN REAR FINAL DRIVE 0BE, FILLING .

-- Install the driveshaft on the rear final drive (See Figure).

-- Install the rear section of the exhaust system. Refer to EXHAUST PIPES/MUFFLERS for engine code CALA, EXHAUST PIPES/MUFFLERS for engine codes CCBA, CGXC, CTUB, or EXHAUST PIPES/MUFFLERS for engine codes CAED, CAEB, CPMB, CPMA .