LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 537 (Final Drive & Differential - Rear Final Drive - Sport Differential (Sedan)) >> 39 Final Drive, Differential >> Rear Final Drive, Removing And Installing >> Rear Final Drive, Additional Work After Replacing

Rear Final Drive, Additional Work After Replacing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, and 2014 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Malfunctions on the rear final drive.

If the rear final drive was replaced, the following additional work is necessary.

  • Bleed the hydraulic control module using the Vehicle Diagnostic Tester.
  • Program the rear final drive on the All Wheel Drive Control Module -J492- use the Vehicle Diagnostic Tester.
  • The additional work can only be performed when the rear final drive is replaced.

Procedure 

-- Connect the Vehicle Diagnostic Tester and switch on the ignition.

-- On the Vehicle Diagnostic Tester select the function 22 - Control Module, Replacing  under Guided Functions  in the directory 22 - Rear Final Drive, Replacing  .

"Adapt" the new rear final drive to the All Wheel Drive Control Module -J492- with the Vehicle Diagnostic Tester.

NOTE:

A system check will take place when the function 22 - Rear Final Drive Replacing  is complete. If malfunctions appear, then use "Guided Fault Finding  " to correct them.

Tightening Specification 

Component Nm
Wiring harness bracket on the rear final drive 9
scientia non olet · About LEMON Manuals