All Wheel Drive Pump -V415-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, and 2014 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

-- Place the vehicle on a lift.

The ignition is off.

-- Place the Drip Tray under the rear final drive.

-- Disconnect the connector -1- from the All Wheel Drive Pump -V415- -2-.

Fig 1: All Wheel Drive (AWD) Pump Connector

Courtesy of AUDI OF AMERICA, LLC

-- Remove the four bolts that connect the All Wheel Drive Pump -V415- to the hydraulic control unit using the Hex Ball Socket T10058.

-- Carefully remove the All Wheel Drive Pump -V415- -2-. Pay close attention to the adapter inside the hydraulic pump while doing this. Refer to -item 4- Adapter (See Figure).

NOTE:

The adapter could fall out when removing the All Wheel Drive Pump -V415-.

Insert the adapter into the recesses in the hydraulic pump before installing the All Wheel Drive Pump -V415-.