All Wheel Drive Pump -V415-, REMOVING AND INSTALLING: Installing
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, and 2014 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
- The hydraulic pump -A- is installed inside the hydraulic control unit. Assembling the hydraulic pump. Refer to Figure.
- The adapter -B- is installed in the recesses in the hydraulic pump.
- A new O-ring -D- is on the All Wheel Drive Pump -V415-.
-- Install the All Wheel Drive Pump -V415- with the coupling -C- in the adapter -B-.
-- Diagonally tighten the four bolts on the All Wheel Drive Pump -V415- -2- to the tightening specification. Refer to -item 1- Bolt (See Figure).
-- Connect the connector -1- to the All Wheel Drive Pump -V415-.
-- Fill with ATF in the rear final drive. Refer to ATF ON REAR FINAL DRIVE 0BF AND 0BE, FILLING .