All Wheel Drive Control Module -J492-, REMOVING AND INSTALLING

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, and 2014 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

All Wheel Drive Control Module -J492- component location. Refer to -item 1- All Wheel Drive Control Module -J492- (See Figure).

Removing and installing is on the A4 Sedan.

The ignition is off.

-- Remove the luggage compartment floor covering.

-- Remove the covering and the vehicle tools mount.

-- Remove the All Wheel Drive Control Module -J492- -A- from the bracket -C-.

Fig 1: All Wheel Drive (AWD) Control Module -J492- In Audi A4 Sedan, Audi A5 Coupe And Audi A5 Cabriolet

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -B- from the All Wheel Drive Control Module -J492-.

-- Install the All Wheel Drive Control Module -J492- in reverse order of removal.

If the All Wheel Drive Control Module -J492- was replaced then additional work is necessary. Refer to All Wheel Drive Control Module -J492-, ADDITIONAL WORK AFTER REPLACING .