Driveshaft, Removing And Installing From Rear Final Drive: Removing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, and 2014 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Driveshaft, Removing from Rear Final Drive

Fig 1: Clamping Sleeves

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the exhaust system at the clamping sleeves -1 and 2-.

-- Tie the front exhaust pipe(s) to the underbody.

NOTE:

Do not bend the flex joint in the front exhaust pipe more than 10° or it will be damaged. Tie up the front exhaust pipes on the body and to the side.

A second technician is needed to help remove the rear section of the exhaust system.

-- Remove the rear section of the exhaust system. Refer to EXHAUST PIPES/MUFFLERS for engine code CALA, EXHAUST PIPES/MUFFLERS for engine codes CCBA, CGXC, CTUB, or EXHAUST PIPES/MUFFLERS for engine codes CAED, CAEB, CPMB, CPMA .

-- Check whether there is a color marking on the driveshaft and at flange/driveshaft on the rear final drive -arrow A- and -arrow B-.

Fig 2: Identifying Marked Position Of Driveshaft Flange To Rear Final Drive

Courtesy of AUDI OF AMERICA, LLC

-- If one of these markings is no longer visible (for example -arrow A- on the driveshaft), then make a mark for the missing colored dot in color.

The mark on the driveshaft -arrow A- and on the rear final drive -arrow B- are on one line.

Rear Final Drive 0BF

Fig 3: Counter Hold Using Counterhold Tool T10172 And Adapters T10172/5

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1- (quantity: 6) from the rear CV joint.

-- Counterhold with Counterhold - Kit - Multiple Use T10172 and Counterhold - Kit - Adapter 5 T10172/5.

-- Remove the driveshaft from the rear final drive and move it to the side of the subframe.

Rear Final Drive 0BE

Fig 4: Driveshaft Center Bearing Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1- (quantity: 6) from the rear CV joint.

-- Counterhold with Counterhold - Kit - Multiple Use T10172 and Counterhold - Kit - Adapter 6 T10172/6.

-- Remove the driveshaft from the rear final drive and move it to the side of the subframe.