Center Differential Housing, Removing And Installing: Removing

Removing the Center Differential and Housing 

-- Remove the rear noise insulation by loosening the fasteners -2- and -3-

Fig 1: Identifying Noise Insulation Components

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Do not bend the flex joint in the front exhaust pipe more than 10° or it will be damaged.

Fig 2: Disconnecting Exhaust System At Double Clamps

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the exhaust system at clamping sleeve(s) -arrows-.

-- Place the Used Oil Collection and Extraction Unit SMN372500 under the transmission.

Fig 3: Locating Transmission Fluid Drain Plug

Courtesy of AUDI OF AMERICA, LLC

-- Remove the plug -arrow- and drain the transmission fluid.

-- Install the bolt -arrow- and tighten it to 40 Nm.

-- Remove the bolts -arrows- and remove the driveshaft heat shield (if equipped) for the driveshaft -A-.

Fig 4: Identifying Driveshaft Heat Shield

Courtesy of AUDI OF AMERICA, LLC

Driveshaft Bolted on the Transmission Side: 

Fig 5: Counterholding Driveshaft Using T10172 And T10172/5

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts attaching the driveshaft to the transmission by counterholding with the Counterhold - Multiple Use T10172A and Counterhold - Kit - Adapters 5-7 T10172/5.

-- Press the driveshaft together with rear final drive; the universal joint is able to slide axially.

-- Secure the driveshaft to the side.

Driveshaft Connected on the Transmission Side: 

-- Remove the driveshaft. Refer to DRIVESHAFT, REMOVING AND INSTALLING . For Sport Differential, refer to 39 FINAL DRIVE, DIFFERENTIAL . .

All Vehicles: 

Fig 6: Supporting Transmission With VAG 1383

Courtesy of AUDI OF AMERICA, LLC

-- Support the transmission using the Engine and Gearbox Jack VAS6931 and the attached Engine/Gearbox Jack - Gearbox Support T10337.

-- Remove the bolts from the tunnel crossmember -arrows-.

Fig 7: Identifying Bolts & Tunnel Crossmember

Courtesy of AUDI OF AMERICA, LLC

-- Lower the transmission to dimension -a- using the Engine and Gearbox Jack VAS6931.

Fig 8: Lowering Transmission To Dimension -A-

Courtesy of AUDI OF AMERICA, LLC

• Dimension -a- = maximum 70 mm.

-- Remove the nuts -arrows- and the tunnel crossmember.

Fig 9: Identifying Nuts & Tunnel Crossmember

Courtesy of AUDI OF AMERICA, LLC

-- Place the Used Oil Collection and Extraction Unit SMN372500 under the transmission.

Fig 10: Locating Center Differential Housing Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -A- and -arrows- for the center differential housing -B- to the transmission.

-- Carefully remove the center differential housing -6-, the pressure spring -3-, the adjusting shim -4- and the plate spring -5-.

Fig 11: Identifying Differential Housing -6-, Pressure Spring -3-, Adjusting Shim -4- & Plate Spring -5-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the center differential -2- and the gear carrier -1-.

If the gear carrier -1- remains in the center differential housing, proceed as follows:

Fig 12: Removing Gear Carrier

Courtesy of AUDI OF AMERICA, LLC

-- Hold the gear carrier -1- by one of the side ribs with pliers and remove it in direction of -arrow A-.

-- Using a Rubber Hammer, tap the housing on alternating sides -B arrows-.

-- Remove the center differential.