All Wheel Drive Control Module -J492-, ADDITIONAL WORK AFTER REPLACING

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, and 2014 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Only perform the additional work only if the All Wheel Drive Control Module -J492- was replaced.

-- Connect the Vehicle Diagnostic Tester and turn on the ignition.

-- Select the function 22 - All Wheel Drive Electronics in the Vehicle Diagnostic Tester under Guided Functions in the directory 22- Replacing Control Module .

Follow all the instructions given by the Vehicle Diagnostic Tester exactly.

With the Vehicle Diagnostic Tester the installed rear final drive is "adapted" on the All Wheel Drive Control Module -J492-.

NOTE:

A system check will take place when the 22 - Control Module, Replacing function is complete. If malfunctions appear, then use "Guided Fault Finding" to correct them.