Input Shaft Seal, Replacing, 0BD: Notes

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, and 2014 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

The flange/driveshaft used before must be installed.
If the flange/driveshaft is also being replaced, do the following. Refer to FLANGE SHAFT RING, REPLACING, 0BD .

Special tools and workshop equipment required

Puller - Multiple Use VW391
Slide Hammer Set VW771
Slide Hammer Set - Hook VW771/37
Seal Installer - Driveshaft Flange T40112
Retainer - Drive Flange 3028
Seal Installer - Wheel Bearing Seal 3143
Holding Fixture - Gearbox Adapter T10235
Friction Gauge VAS6222
Inductive Heater VAS6414
Sealing Grease G 052 128 A1
Locking Fluid AMV 185 101 A1
Three M8 x 25 bolts
Two M10 x 40 bolts