Flange Input Shaft Ring, Replacing, 0BD
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, and 2014 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
- The ring can only be replaced with the input shaft removed.
Special tools and workshop equipment required
- Press Plate VW402
- Press Piece - Rod VW407
- Press Piece - Multiple Use VW412
- Bearing Installer - Multiple Use 40 - 20
- Separating tool 22 to 75 mm, such as 17/1
- Input shaft removed. Refer to INPUT SHAFT SEAL, REPLACING, 0BD .
A -
Separating Tool - 22-115mm, such as Puller - Kukko Quick Action Separating Tool - 22-115mm 17/2
- Protective ring -A- installation position: the protective ring notch points upward to the Bearing Installer - Multiple Use 40 - 20.