Flange Input Shaft Ring, Replacing, 0BC

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, and 2014 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

The ring can only be replaced with the input shaft removed.

Special tools and workshop equipment required

Bearing/Bushing Installer - Multiple Use VW295A
Press Plate VW402
Press Piece - Rod VW408A
Support Channels VW457
-3- Separating device 12 to 75 mm, for example Puller - Kukko Quick Action Separating Tool - 12-75mm17/1

Input shaft removed. Refer to INPUT SHAFT SEAL, REPLACING, 0BC .

Fig 1: Removing Ring -A- From Flange/Driveshaft

Courtesy of AUDI OF AMERICA, LLC

B -

Puller, for example, Puller - Kukko Quick Action Separating Tool - 12-75mm 17/1

Fig 2: Identifying Flange And Groove Position

Courtesy of AUDI OF AMERICA, LLC

The ridge -arrow 1- on the protective ring -A- must fit into the groove -arrow 2- on the flange -B-. The smaller outer circumference -arrow 3- faces the flange.

Fig 3: Identifying Ring -A- Onto Flange/Driveshaft, Installation

Courtesy of AUDI OF AMERICA, LLC

The protective ring -A- must fit into the groove all around the flange. Refer to Fig 2.