Gear Oil, Checking Level, 0BC

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, and 2014 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Drip Tray

-- Remove the plug to check the transmission fluid level -arrow-.

Fig 1: Locating Rear Final Drive Plug For Checking Fluid Level (0BC)

Courtesy of AUDI OF AMERICA, LLC

The oil level is correct when the rear final drive is filled up to the lower edge of the oil fill hole.

Use correct transmission fluid specification. Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article.

-- Install the plug -arrow- and tighten it.

Tightening specification 30 Nm.