Overview - Final Drive 0BC, 0BD: Notes
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, and 2014 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
Rear Final Drive
- Subframe
- Removing and installing. Refer to OVERVIEW - SUBFRAME .
- Bolt
- 95 Nm
- Bolt
- 55 Nm
- Bolt
- 55 Nm
- Depending on the date of manufacture for the balance weight fastener. Refer to OVERVIEW - FINAL DRIVE 0BC, 0BD - BALANCE WEIGHT ON THE REAR FINAL DRIVE .
- Heat Shield
- Bolt
- 20 Nm
- Driveshaft
- Removing and installing. Refer to DRIVE AXLE, REMOVING AND INSTALLING .
- Rear Final Drive
- Versions with balance weight. Refer to OVERVIEW - FINAL DRIVE 0BC, 0BD - BALANCE WEIGHT ON THE REAR FINAL DRIVE .
- Refer to FINAL DRIVE, REMOVING AND INSTALLING
- Driveshaft
- Removing and installing. Refer to DRIVESHAFT, REMOVING AND INSTALLING .
- Removing and installing on the rear final drive. Refer to DRIVESHAFT, REMOVING AND INSTALLING FROM REAR FINAL DRIVE .
- Crossmember