All Wheel Drive Clutch Valve -N445- OR All Wheel Drive Clutch Valve 2 -N446-, REMOVING AND INSTALLING, 0BE, 0BF: Installing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, and 2014 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Clutch Valves

Courtesy of AUDI OF AMERICA, LLC

The ball -5-, the guide -4- (the smaller diameter faces the spring) and the spring -3- must be installed in the housing opening -6- for the Clutch Valve -2-.

-- Coat the O-rings with ATF and install the new Clutch Valve -- with the new O-rings -arrows-.

-- Tighten the bolts -1- evenly until stop by hand. Then tighten to the tightening specification. Refer to -item 13- Bolt (See Figure).

Further installation is performed in the reverse order of the removal. Note the following.

NOTE:

Allocation for the Oil Pressure/Temperature Sensor -- and Clutch Valves -- connectors:

Fig 2: Identifying Oil Pressure/Temperature Sensor Connectors

Courtesy of AUDI OF AMERICA, LLC

-1- = Oil Pressure/Temperature Sensor 2 -G640- Connector

-2- = Oil Pressure/Temperature Sensor -G437- Connector

-3- = All Wheel Drive Clutch Valve 2 -N446- Connector

-4- = All Wheel Drive Clutch Valve -N445- Connector

-- Attach the wiring harness bracket to the rear final drive. Refer to INSTALLING - "Position the bracket -1- on the final drive".

-- Fill the ATF in the rear final drive. Refer to ATF, FILLING, 0BE, 0BF .

-- Install the rear section of the exhaust system on the body and align it so it is free of tension. Refer to EXHAUST PIPES/MUFFLERS for engine code CALA, EXHAUST PIPES/MUFFLERS for engine codes CAED, CAEB, CPMB, CPMA, or EXHAUST PIPES/MUFFLERS for engines CCBA, CGXC, CTUB .