Overview - Fuel Tank (Vehicles With Fwd And AWD)
WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- Tightening specification. Refer to OVERVIEW - MUFFLER for 2.0L, engine codes CAED, CAEB, CPMB, CPMA, refer to OVERVIEW - MUFFLER for 3.0L, enginge codes CCBA, CGXC, CTUB, or refer to OVERVIEW - MUFFLER for 3.2L, engine code CALA .
- Exhaust System Suspended Mount
- Mounting Strap
- Fuel Line
- From the fuel filter to the engine
- Do not kink
- Clipped to the fuel tank
- To disconnect, press release button on connection piece. Refer to CONNECTOR COUPLINGS, SEPARATING .
- Bolt
- 6 Nm
- Protective Plate
- For the fuel filler tube
- Overflow Hose
- Attached to the bumper bracket
- Rubber Gasket
- Cap
- Turn until it clicks and locks.
- Attached to tank flap unit with fastening device
- Bolt
- 20 Nm
- To attach the fuel filler neck
- Discharging electrostatic charge. Refer to Fig 3.
- Fuel Tank
- Removing and installing. Refer to FUEL TANK WITH ATTACHMENTS, REMOVING AND INSTALLING, VEHICLES WITH FWD AND AWD .
- Breather Line
- To the EVAP canister
- Do not kink
- To disconnect, press release button on connection piece. Refer to CONNECTOR COUPLINGS, SEPARATING .
- Clipped to the fuel tank
- Fuel Tank Heat Shield
- Nut
- 2 Nm
- Nut
- 2 Nm
- Support Plate
- Fuel Tank Heat Shield
- Nut
- 2 Nm
- Bolt
- 20 Nm
- Nut
- 2 Nm
- Expanding Clip
-- Tighten the bolts -arrows- to 1.5 Nm.
-- Make sure the filler tube threaded connections -1 and 2- are free of corrosion so the GND connection to the body is not affected.
WARNING:
Risk of explosion due to electrostatic charge.
- After installing, check electrical connection on fuel filler neck metal ring to an empty spot on the body using an Ohm meter.
- Specified value: approximately 0 Ω.