STARTER, REMOVING AND INSTALLING, Vehicles with 2.0L TFSI Engine: Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- With the ignition switched off, disconnect the battery ground cable. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove the right engine mount. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .

-- Remove the nut -1- and free up the ground cable on the engine support.

Fig 1: Identifying Nut And Ground Wire On Engine Mount Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and the right engine support.

-- Remove the bolt -1- for the cable holder -2-.

Fig 2: Identifying Bolt On Wiring Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -3- by sliding the retainer back and pressing the release down.

Fig 3: Disconnecting Starter Electrical Connector

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the wire -2- from the starter.

-- Remove the bolts -1- and -4- and remove the starter.

NOTE:

-Item 1- can be reached from above.