Warranty Test, Performing
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Do not check or charge a Battery -A- when the visual indicator has >>no color or is bright yellow<<. Jump starting must not be used!
There is a risk of explosion during testing, charging or jump starting.
These Batteries -A- must be replaced.
Procedure
-- Select "Warranty Test".
-- Select "inside the vehicle" or "outside of the vehicle".
-- Select "at the battery pole" or "at the battery jump start terminal".
-- Section8 vehicle model.
-- Determine the temperature above the Battery -A-. Hold the infrared sensor approximately 5 cm above the battery pole until the temperature is stable.
-- Select battery type (Normal, AGM, 2*6 V or Gel).
-- Select battery capacity.
-- Start the test.
-- Print out the test notes.