Test Result Evaluation
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Evaluating the Battery Test Results for the Warranty and Service Tests
| Battery Test Result | Measure |
|---|---|
| Battery -A- good | No measure on the Battery -A-. |
| Battery -A- good - recharge | -- Charge the Battery -A- (Refer to BATTERY, CHARGING ) and determine why the battery is discharging. |
| Perform a current draw test | -- Perform a current draw test. Refer to CURRENT DRAW TEST . -- Charge the Battery -A- and perform the test again. Refer to BATTERY, CHARGING . |
| Battery -A-, replacing | -- Disconnect the Battery -A- and perform the test again. The result "replace the battery" can occur due to a weak cable contact. |
| Battery cell faulty - replace | -- Replace the Battery -A-. Refer to BATTERY, REMOVING AND INSTALLING . |
| Check the connection | -- Attach the test terminals directly to the Battery -A- and not to the battery jump start terminal. |
Evaluating the Battery Test Results for the Maintenance test
| Battery Test Result | Measure |
|---|---|
| Battery -A- good | No measure |
| Battery -A-, charge immediately | -- Charge the Battery -A-. Refer to BATTERY, CHARGING . |
| Mark as defective | -- Mark the Battery -A- as "defective". |
| Check the tester connection | -- Disconnect the Battery -A- and perform the test again. The result "check the tester connection" can occur because the cable contact from the test terminals is weak. |
| Check the connection | -- Attach the test terminals directly to the Battery -A- and not to the battery jump start terminal. |
| Noises | Wait until the measured value appears in the display. |