Maintenance Test, Performing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Do not check or charge a Battery -A- when the visual indicator has >>no color or is bright yellow<<. Jump starting must not be used!

There is a risk of explosion during testing, charging or jump starting.

These Batteries -A- must be replaced.

Procedure

-- Select "Maintenance Test".

-- Connect the scanner.

NOTE:

If there is no scanner, manually enter the VIN on the printed test results.

-- Scan the VIN.

-- Select "at the battery pole" or "at the battery jump start terminal".

-- Section vehicle model.

-- Scan the barcode or manually select the "type and manufacturer" in the menu.

-- Determine the temperature above the Battery -A-. Hold the infrared sensor approximately 5 cm above the battery pole until the temperature is stable.

-- Start the test.

-- Print out the test notes.