Ribbed Belt, Removing And Installing: Installing

WARNING: This page is about a different car, the 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Placing Ribbed Belt Over Belt Pulley

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

-- Route the ribbed belt over the ribbed belt pulley in the sequence specified.

Generator
Idler Roller
Coolant Pump
Power Steering Pump
A/C Compressor
Ribbed belt tensioner
Vibration Damper with Ribbed Belt Pulley

NOTE:

When installing the ribbed belt, make sure it is seated correctly on the pulleys.

-- Start the engine and check the belt routing.

-- Install the front noise insulation. Refer to OVERVIEW - NOISE INSULATION .