Vibration Damper, Removing And Installing: Installing: Notes

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi A4 Quattro, 2014 Audi A4 Quattro, and 2013 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

Replace the bolt with the O-ring after removing.

If necessary, remove the -T10531/4- -B- and -T10531/3- -Afrom the -T10531/2-.

Courtesy of
Attach the vibration damper in TDC. While doing so, pay attention to the tooth contour of the chain sprocket -arrow-.

Courtesy of

Place the -T10531/3- -A- on the -T10531/2-.
- At the same time the hex fitting points to the vibration damper.
Install the -T10531/4- -B-. While doing so, move the vibration damper back and forth slightly to check if the vibration damper is seated correctly in the tooth contour.
Tighten the knurled nut until the vibration damper can no longer be turned.

Courtesy of

Place the -T10531/1- as shown on the vibration damper and tighten hand-tight using the knurled bolt -arrows-.
- The arrow marking on the - T10531/1- must point upward.
Courtesy of

Remove the -T10531/4- -A- and loosen the tensioning pin -B-.
Unscrew the -T10531/2- and remove it with the -T10531/3-.

Courtesy of

Install a new vibration damper bolt hand-tight with an oiled O-ring -1-.

Courtesy of
Remove the knurled bolts -arrows- and remove the - T10531/1-.

Courtesy of
Position the -T10355- and tighten the vibration damper bolts.

Courtesy of

Further installation is performed in reverse order of removal, while noting the following:

Replace the timing chain cover bolts -arrows- after removing.

Courtesy of

Non-hybrid vehicles: install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

There are additional procedures depending on the model. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .