Sensor Module --, WITH INTEGRATED TRANSMITTERS AND SENSORS -G612-, -G632-, -G676 - AND Circuit Board 3 --, REMOVING AND INSTALLING: Notes

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2018 Audi S6, 2017 Audi S6, 2016 Audi S6, 2016 Audi S4, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Caution:

Do not use the Hook And Support Tool T40197 for the following described work procedures - There is a risk of injury.

Only use the Hook and Support Tool T40294 for this operation.

Special tools and workshop equipment required

Hook and Support Tool T40294
Counterhold - Side Shaft T40217
Sensor Module Tool T40228
Sealant.

NOTE:

The Transmission Input Speed Sensor 2 -G612-, Transmission Input Speed Sensor 1 -G632-, Drive Position Sensor -G676- and Circuit Board 3 -- are integrated in the Sensor Module --. The components can only be replaced as a single Sensor Module -- unit.

Replace the wiring set for the sensor module (Refer to -item 39- Wiring Set) when replacing the Sensor Module (See Figure).