Mounting 2.0L TFSI engine on the manual transmission
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2016 Audi S4, 2015 Audi S4, 2014 Audi S4, 2013 Audi A4, and 2012 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of AUDI OF AMERICA, LLC
| Item |
Bolt |
Nm |
| 1 1) |
M10x50 2) |
65 |
| 2 3) |
M12x100 4) |
30 + 90° |
| 3 5) |
M12x75 4) |
30 + 90° |
| 4, 5 5) |
M12 x 120 4) |
30 + 90° |
| 6 |
M12x75 4) |
30 + 90° |
| 7 |
M12x100 4) |
30 + 90° |
| 8 to 10 |
M10x75 4) |
15 + 90° |
| 11 |
M12 x 50 4) |
30 + 90° |
| A |
Alignment sleeves for centering |
- Mount the auxiliary adapter
- Steel bolt - do not replace
- Also secures that starter; with an additional spacer sleeve between the starter and the transmission.
- Check if the aluminum bolts can be used again , if not, replace them.
- Also attaches the bracket for the electric wire.
|
- The aluminum bolts -2 through 10- can be used twice. Therefore, the bolts must be marked with two notches "X" made by a chisel after they have be used the first time -arrow-
.
Courtesy of AUDI OF AMERICA, LLC
- Bolts marked with an "X" may not be used again.
- There is no limit to the number of times steel bolts -1- can be used.