Transmission Range Gear Recognition Switch -F208-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2016 Audi S4, 2015 Audi S4, 2014 Audi S4, 2013 Audi A4, and 2012 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

-- Install the Transmission Range Gear Recognition Switch -F208- in the selector shaft cover. Tightening specification. Refer to Tightening Specification .

Fig 1: Installing Connector On Transmission Range Gear Recognition Switch

Courtesy of AUDI OF AMERICA, LLC

-- Install the connector -2- on the Transmission Range Gear Recognition Switch -F208-.

NOTE:

Disregard items -1 and 3-.

-- Install the tunnel crossmember -arrows-, refer to -item 2- Bolt.

Fig 2: Identifying Tunnel Crossmember And Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Assemble the exhaust system making sure it is not under stress. Refer to EXHAUST PIPES/MUFFLERS for 2.0L, engine codes CAED, CAEB, CPMB, CPMA, EXHAUST PIPES/MUFFLERS for 3.0L, engine codes CCBA, CGXC, CTUB, or EXHAUST PIPES/MUFFLERS for 3.2L, engine code CALA .

-- Install the noise insulation. Refer to OVERVIEW - NOISE INSULATION .