Transmission Neutral Position Sensor -G701-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2016 Audi S4, 2015 Audi S4, 2014 Audi S4, 2013 Audi A4, and 2012 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Noise Insulation

GWWA10-11100

Courtesy of AUDI OF AMERICA, LLC

-- Where equipped, remove rear noise insulation -2-.

-- Move the gearshift lever -2- forward in direction of -arrow- and shift into 4th gear.

Fig 2: Identifying Gearshift Assembly

GWWA34-10577

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore item -1-.

-- Disconnect the connector from the Transmission Neutral Position Sensor -G701- -arrow-.

Fig 3: Locating Transmission Neutral Position Sensor (Through MY 2013)

GWWA10-11357

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -arrow- and remove the Transmission Neutral Position Sensor -G701- -A-.

Fig 4: Removing Transmission Neutral Position Sensor

GWWA34-10786

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The cover -B- remains installed.