Transmission Neutral Position Sensor -G701-, REMOVING AND INSTALLING: Installing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2016 Audi S4, 2015 Audi S4, 2014 Audi S4, 2013 Audi A4, and 2012 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
-- Install the Transmission Neutral Position Sensor -G701- -A- with a new O-ring in the gearshift shaft cover -B-.
-- Tighten the new bolt -arrow- to the tightening specification. Refer to Tightening Specification .
-- Connect the connector to the Transmission Neutral Position Sensor -G701- -1-.
-- Install the noise insulation. Refer to OVERVIEW - NOISE INSULATION .