Gear Recognition Sensor -G604-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2016 Audi S4, 2015 Audi S4, 2014 Audi S4, 2013 Audi A4, and 2012 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

-- Replace the O-rings -4-.

CAUTION:

There is a risk of breaking or causing malfunctions in the Gear Recognition Sensor -G604- during installation.

The Gear Recognition Sensor -G604- -3- may not be banged or bolted -1- into the transmission.
The O-rings -4- and the opening in the transmission cover must be lubricated with transmission fluid.
The Gear Recognition Sensor -G604- -3- may be lightly pressed on with an aid, for example a hammer shaft.

-- Secure the Gear Recognition Sensor -G604- with the bolt -1-. Tightening specification. Refer to Tightening Specification .

-- Connect the connector -1- and lock if necessary.

Fig 1: Locating Gear Recognition Sensor

Courtesy of AUDI OF AMERICA, LLC

-- Install the tunnel crossmember -arrows-, refer to -item 2- Bolt.

Fig 2: Identifying Tunnel Crossmember And Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Assemble the exhaust system making sure it is not under stress. Refer to EXHAUST PIPES/MUFFLERS for 2.0L, engine codes CAED, CAEB, CPMB, CPMA, EXHAUST PIPES/MUFFLERS for 3.0L, engine codes CCBA, CGXC, CTUB, or EXHAUST PIPES/MUFFLERS for 3.2L, engine code CALA .

-- Install the noise insulation. Refer to OVERVIEW - NOISE INSULATION .