Tunnel CROSSMEMBER, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2016 Audi S4, 2015 Audi S4, 2014 Audi S4, 2013 Audi A4, and 2012 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Noise Insulation Components

Courtesy of AUDI OF AMERICA, LLC

-- Remove the rear noise insulation by loosening the fasteners -2 and 3-

-- Mount the Engine and Gearbox Jack VAS6931 thrust plate together with the lower Engine/Gearbox Jack - Gearbox Support T10337 on the tunnel crossmember.

Fig 2: Supporting Transmission With VAG 1383

Courtesy of AUDI OF AMERICA, LLC

-- Lift the transmission slightly using the Engine and Gearbox Jack VAS6931.

WARNING:

There is the risk of an accident.

The Engine and Gearbox Jack VAS6931 may only be used during assembly and must not sit unsupervised under the vehicle.

-- Remove the bolts from the tunnel crossmember -arrows-.

Fig 3: Identifying Tunnel Crossmember And Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -arrows- and the tunnel crossmember.

Fig 4: Identifying Tunnel Crossmember And Nuts

Courtesy of AUDI OF AMERICA, LLC