Mounting the 3.0L TFSI Engine to Manual Transmission

WARNING: This page is about a different car, the 2013 Audi S4, 2012 Audi S4, 2011 Audi S4, and 2010 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Checking If Alignment Sleeves -A- For Centering Engine/Transmission Are In Cylinder Block

Courtesy of AUDI OF AMERICA, LLC

Item	Bolt	Nm
1 ¹⁾	M10 x 50 ²⁾	65
2 ¹⁾	M12 x 100 ³⁾⁴⁾	30 + 90°
3 to 6	M12 x 100 ³⁾⁴⁾	30 + 90°
7	M12 x 125 ³⁾⁴⁾	30 + 90°
8, 11	M10 x 60 ³⁾⁴⁾	15 + 90°
9, 10	M10 x 95 ³⁾⁴⁾	15 + 90°
A	Alignment sleeves for centering
also secures the starter. Bolt strength rating 10.9. There is no limit to the number of times steel bolts may be used. Audi A4 through VIN 8K-9-066499, and Audi A5 through VIN 8T-9-007999: replace the aluminum bolts. Audi A4 from VIN 8K-9-066500, Audi A5 from VIN 8T-9-008000: Aluminum bolts may be used two times.
Check if the aluminum bolts -2 through 11- can be used again. Refer to Fig 2.

Checking if the Aluminum Bolts -2 through 11- Can Be Used Again.

Fig 2: Identifying Bolts Marked With An "X"

Courtesy of AUDI OF AMERICA, LLC

Audi A4 from VIN 8K-9-066500, Audi A5 from VIN 8T-9-008000: The aluminum bolts (refer to the illustration) may be used two times. Therefore, the bolts must be marked with two notches "X" made by a chisel after they have be used the first time -arrow-.
To prevent damaging the bolts when marking them, do not clamp them in a vise. Insert the bolt using a 14 mm socket with a 1/2 drive, which is inserted in to the vise, as illustrated.
Bolts marked with an "X" may not be used again .
Audi A4 through VIN 8K-9-066499: always replace the aluminum bolts.
Audi A5 through VIN 8T-9-007999: always replace the aluminum bolts.
There is no limit to the number of times the steel bolt can be used again.